Table of Contents
Advertisement
KWO5000
record its TCP/IP configuration settings.
3.
Configure the computer with a static IP address of 192.168.1.x (x cannot be 1)and
255.255.255.0 for the Subnet Mask.
Please follow the steps below to complete installing of your
KWO5000.
Hardware Installation
4.
Combine the external antennas into the antenna connector.
Note
Make sure that you connect tightly the External antenna on the antenna
connector of your KWO5000 AP. A loosen antenna will reduce the
radiant energy or even lose it. In order to improve the RF signal radiation
of your antenna, proper antenna placement is necessary. Try to place the
antenna as high as possible to increase the coverage area.
Connect one end of an Ether cable to the KWO5000 AP and connect the other end to the Ethernet
LAN port located on your PC.
Turn on your computer, connect the power adapter to the KWO5000 and verify the following:
The PWR power light goes on.
The LAN light of the wireless access point is lit when connected to a powered on
computer.
Configuring the TCP/IP Settings of Your PC
Make sure the TCP/IP protocol has been installed in your PC. Please take the
Advertisement
Table of Contents
