Table of Contents
Advertisement
Chapter 2.
System Requirements
Before installing the AG-3621 access point, make sure your system meets these
requirements.
The Category 5 UTP straight through Ethernet cable with RJ-45 connector included in the
package, or one like it.
A 230 V, 50 HZ AC power source.
A Web browser for configuration such as Microsoft Internet Explorer 6.0 or above, or Netscape
Navigator 4.78 or above.
At least one computer with the TCP/IP protocol installed
What's In the Box?
FWS Wireless Access Point 802.11a/b/g AG-3621
Power adapter and cord
Two Dual-Band Omni-directional antennas
AG-3621 11a/b/g Wireless Access Point Installation Guide
Resource CD for the FWS AG-3621 Wireless Access Point
Support Registration card
Hardware Description
We'll discuss the AG-3621 front and rear functions.
The LEDs
The Access Point's LEDs, where information about network activity is displayed, are located
on the front panel.
LED
PWR
Off
On
TEST
Off
On
Blink
Basic Installation
DESCRIPTION
No power. If this LED does not come on with the power adapter
and cord correctly installed
Power is on.
Indicates that leaving boot-code mode
Indicates that entering boot-code mode
Reset button is pressed around 3 seconds (slow blinking).
Reset button is pressed after 3 seconds(fast blinking)
Whlie you upgrade firmware or reset to factory default,the TEST
6
Advertisement
Table of Contents
