Slideout Room - Extreme Weather Precaution; Slideout Room Troubleshooting (Lippert) - Winnebago Minni Winni Owner's Manual

SLIDEOUT ROOM – EXTREME
WEATHER PRECAUTION
Certain extreme weather conditions, such as
heavy rains, heavy snow, and high winds, or any
combination of these, could cause damage to the
slideout room cover-awning (if equipped) or
reduce effectiveness of the slideout room weather
seals.
Slideout Cover-Awning
-Typical View
Also, freezing rain and snow can prevent the
slideout cover-awning (if equipped) from closing
and may cause damage to the cover-awning,
slideout room, weather seals, and mechanisms.
To avoid potential damage, we recommend
retracting your slideout room during extreme
weather conditions.
SLIDEOUT ROOM
TROUBLESHOOTING
(LIPPERT)
–If Equipped
Battery Voltage or Circuit Breaker
Problems
If the slideout room will not work:
• Turn the House/Coach Battery Disconnect
switch OFF and then ON again. This will, in
many cases, reset power to the slideout
system.
SLIDEOUT ROOMS
• The house battery may be low on charge. Plug
in the external power cord (shoreline), start
the engine, or start up the generator (if
equipped). This may assist slideout room
operation.
• The circuit breaker may be tripped. The
circuit breaker, labeled "Slideout Power" is
located on a panel on an interior wall of the
passenger side storage compartment just
behind or ahead of the entrance door.
•Motor
•Statu
Direction
s
•Motor 1
Connection
Slideout Room Controller
(Located in a driver or passenger side
compartment, depending on model)
- Remove panel to access
Error Codes
When an error occurs during slideout room
operation, the slideout control panel (located in
passenger side compartment) will use LED
display lights to indicate where the problem
exists.
For specific motor faults, the green LED light
will blink 1 time for Motor 1 and 2 times for
Motor 2. The red LED light will blink from 2 to
9 times, depending on the error code. The error
codes are as follows:
• (2) - BATTERY DROP OUT. Battery
capacity low enough to drop below 6 volts
while running.
• (3) - LOW BATTERY. Voltage below 8 volts
at start of cycle.
SECTION 10 –
•Mode
Button
•Motor 2
Connection
10-3