Dell S500 User Manual page 63

W /LAN—
Select On to activate the Wireless/LAN function. You
IRELESS
can also set the Wireless/LAN module to on/off while the projector is in the
standby status.
W S —
IRELESS ETTINGS
menu. See "Wireless/LAN Settings (in Wireless Mode)" on page 64.
DHCP—
If a DHCP server exists in the network to which the projector is
connected, the IP address will automatically be acquired when you select
DHCP On. If DHCP is Off, manually set the IP Address, Subnet Mask,
and Gateway. Use
Mask, and Gateway. Key in enter to confirm each number and then use
and to set the next item.
IP A —
Automatically or manually assigns the IP address to the
DDRESS
projector connected to the network.
S M —
Configure the Subnet Mask of the network connection.
UBNET ASK
G —
Check the Gateway address with your network/system
ATEWAY
administrator if you configure it manually.
DNS—
Check the DNS Server IP address with your network/system
administrator if you configure it manually.
S —
Press to save the changes made in network configuration
TORE
settings.
NOTE:
1. Use
and
Gateway, DNS, and Store.
2. Press the
DNS to set the value. (The selected option is highlighted in blue)
a Use
b Use
c After the setup is complete, press the
3. After the IP Address, Subnet Mask, Gateway, and DNS is set up,
select Store and press
http://www.pureglare.com.au
Select and press
and to select the number of IP address, Subnet
button to select IP Address, Subnet Mask,
button to enter IP Address, Subnet Mask, Gateway or
and button to select the option.
and button to set the value.
button to store the settings.
to activate the Wireless Settings
button to exit.
Using Your Projector
63