Back Plate Installation - Metrologic MS770 Installation And User Manual

Back Plate Installation

With the Metrologic back plate
(Part #45473), position the scanner
in one of two directions. The two
orientation choices are vertical or
horizontal. (Refer to Figure 4). To
use this stand, use the four 6-32 x ½
inch machine screws and four wood
screws to attach the unit to the back
plate and work surface. The maxi-
mum distance the screws should go
into the scanner is a ½ inch.
1. Drill four holes into the work surface that correspond with the holes
indicated by an XY in Figure 5.
2. To fasten the scanner to the back plate:
! For a horizontal mount, align the four holes on the back of the
scanner with the four clearance holes located on the back plate
marked with an X in Figure 5.
! For a vertical mount, align the four holes on the back of the
scanner with the four clearance holes located on the back plate
marked with a Y in Figure 5.
3. Fasten the scanner to the back plate by inserting the four 6-32 x ½ inch
screws into the four holes in the scanner's case. Fasten the scanner and
back plate to the work surface.
Figure 5
Figure 4
5