Configuration To The Host System - Metrologic MS770 Installation And User Manual

Configuration to the Host System

The scanner is shipped from the factory programmed to a set of default
conditions noted in the ScanSelect Scanner Programming Guide by an asterisk
that appears before the brief definition located next to the bar code.
In order for the scanner to communicate with a host system properly, it may
need to be programmed. Since each host system is unique, configure the
scanner to match the host system requirements. Configure the scanner by
entering the program mode and scanning the appropriate bar codes that appear
in the ScanSelect Scanner Programming Guide. (To use ScanSet™, refer to
the ScanSet documentation for information on how to configure a scanner.)
1. Connect the scanner to the host system (Refer to the Scanner
Connections to the Host section in this guide).
2. Enter program mode by scanning the ENTER/EXIT program mode bar
code. (The unit will beep three times)
3. Scan the appropriate bar code(s) that appear in the ScanSelect Scanner
Programming Guide. (Reveal only one bar code to the scanner each
time. With your hand, cover the bar code not to be scanned.)
4. Exit program mode by scanning the ENTER/EXIT program mode bar
code again. (The new options will be saved and the scanner is ready for
normal operation.)
3