Table of Contents
Advertisement
C
ONFIGURATION OF THE
The MS860/MS863 is shipped from the factory programmed to a set of default
conditions noted in the Default Settings section of this guide and in the
®
ScanSelect
Scanner Programming Guide provided. The default settings in the
ScanSelect guide have an asterisk that appears before the brief definition next to
the bar code.
Since each host system is unique, the scanner will need to be configured to
match the specific host system's requirements. If using ScanSet
ScanSet documentation for information on how to configure the scanner.
To configure the MS860/MS863
1.
Connect the scanner to the host system (refer to page 3).
2.
Enter program mode by scanning the ENTER/EXIT program mode bar code
(the unit will beep three times).
3.
Scan the appropriate bar code(s) that appear in the ScanSelect Scanner
Programming Guide.
Note: Reveal only one bar code to the scanner at a time. With your hand,
cover the bar code that is not to be scanned.
4.
Exit program mode by scanning the ENTER/EXIT program mode bar code
again.
Note: Non-RS-232 interfaces chosen in Section B of the ScanSelect
Programming Guide do not match the default settings that are loaded
when the same interface is selected with ScanSet.
4
S
CANNER TO THE
H
S
OST
YSTEM
®
, refer to the
Advertisement
Table of Contents
