Insert Placement - Vermont Castings 380IDVNVSB Installation And Operating Instructions Manual

PRE-INSTALLATION INFORMATION

INSERT PLACEMENT

•
The insert must be placed within a code-conforming
masonry fireplace or a tested and listed zero-clear-
ance (UL-127, solid fuel) fireplace. Repair any fireplace
damage prior to installation.
•
Because the insert uses a circulation blower, clean the
fireplace, smoke shelf and chimney before installing.
•
This heater may be placed in a bedroom. Please be
aware of the large amount of heat this appliance pro-
duces when determining a location.
For minimum
dimensions,
Refer to Page
8
FP2624
Figure 5 -
Insert Placement
20306756
Run the on/off
switch wires to the
right - behind the
surround panels
FP2624
insert placement
380IDV Fireplace Insert
For tight fits you may remove the
manifold. Refer to "Remove the
Manifold" Section
The insert protrudes into
the fireplace. Refer to
Page 8 for dimensions.
The gas line should be
installed prior to insert
placement
Use the leveling bolts for
fireplaces with recessed
floors
Run the power cord
either side of the
insert along the face
9