Firebox Cleaning; Maintaining Heater's Appearance - Vermont Castings 380IDVNVSB Installation And Operating Instructions Manual

380IDV Fireplace Insert

FIREBOX CLEANING

1. Carefully remove log set, and embers from combustion
chamber.
2. Vacuum burner compartment thoroughly.
3. Vacuum any dust off logs.
4. Remove any lint from main burner and pilot.
5. Carefully replace log set, and embers in their correct
positions. Refer to pages 20 - 21.
6. Replace door.
7. Relight pilot. Refer to Page 25.
8. Turn on main burners.
•
Allow logs to cool completely before
cleaning. Logs reach high temperatures.
•
Make sure clearances to combustibles
leave enough room for maintenance and
service.
•
Carefully reassemble and reseal insert
properly after any cleaning or servicing.
MAINTAINING YOUR HEATER'S
APPEARANCE
Fingerprints or other marks left on optional gold or nickel
surface may become etched in place if they are not wiped
clean prior to turning stove on. Clean gold or nickel with a
50/50 vinegar and water solution and soft cloth.
NOTE: Make sure heater is cool before cleaning. Using
cleaners other than a 50/50 vinegar and water solution
may leave a film that becomes permanently etched into
the gold or nickel.
30
CLEANING AND MAINTENANCE
20306756