Eliminating Malfunctions - Cleanfix Robo 40 Operating Instructions Manual

Malfunction
No suction power, the water
stays where it is
Suction bar makes stripes
No water on the brush
Machine has no electrical
functions
Leave any other repairs and service work up to a Cleanfix technician.

- Eliminating Malfunctions -

Cause
Suction bar plugged with residual dirt or
suction bar not installed correctly
Tank lid not closed
Dirty water drain hose not sealed
Suction lips worn
Residual dirt under suction lip
Fresh water pump not in operation
Suction hose not in membrane bag
Water lines plugged
Fresh water hose kinked
Battery connecting cable loose
Battery empty
Emergency stop button pressed
Key switch not in "on" position
Faulty fuse
- NOTES -
Remedy
Clean suction bar and check installation
Close tank lid
Close seal
Renew suction lips
Clean suction lip and suction bar
Call Cleanfix service hotline
Open lid and put suction hose in right
position
Rinse lines (see "Care" chapter)
Check hose
Tighten battery connections
Charge battery
Reset switch
Turn key switch to the right
Install new fuse
(only service personnel)