PEUGEOT 208 Handbook page 129

On / Pause
A first press on this button switches the speed
limiter on, a second press pauses it (OFF).
Exceeding the registered
limit speed
Pressing the accelerator pedal to exceed
the registered speed will not have any effect,
unless you press the pedal firmly past the
point of resistance.
The speed limiter is deactivated temporarily
and the registered speed setting flashes,
accompanied by an audible signal.
To return to normal operation of the speed
limiter, reduce the speed of the vehicle to below
the registered speed setting.
Flashing of the speed setting
It flashes:
- after forcing the accelerator pedal past the
point of resistance,
- when the limiter cannot prevent the speed
of the vehicle increasing, because of the
profile of the road or when going down a
steep hill,
- under sharp acceleration.
Switching off the function
F Place the thumb wheel at the 0 position or
switch off the ignition to stop the system.
The last speed registered stays in memory.
127
Operating fault
The registered speed is erased, then replaced
by three dashes.
Have the system checked by a PEUGEOT
dealer or a qualified workshop.
Good practice
In no circumstances can the speed
limiter replace the need to observe
speed limits or the need for vigilance on
the part of the driver.
Be aware of the effect of the profile
of the road and sharp acceleration,
maintaining control of the vehicle at all
times.
To avoid any risk of interference below
the pedals:
- ensure that the mat and its fixings
on the floor are positioned correctly,
- do not fit one mat on top of another.
Driving
5