Troubleshooting - First Degree Fitness Viking 2 AR Owner's Manual

Troubleshooting:

Fault
Water changes col-
our or becomes
cloudy.
Rower Belt slipping
off belt/ bungee pul-
ley.
Inconsistent read-
ings on the Viking 2
AR Rower Comput-
er for 500meter split
time and SPM
(strokes per mi-
nute).
The Viking 2 AR
Rower Computer
does not illuminate
after battery installa-
tion.
The Viking 2 AR
Rower Computer
screen illuminates,
but does not register
when rowing.
Probable Cause
Rower is in direct
sunlight or has not
had water treat-
ment.
Local tap water is
of poor quality.
Bungee not under
enough tension.
Recoil not strong
enough
Sensor gap
Faulty Sensor
Sensor has moved
out of position
Wiring harness
Batteries installed
incorrectly or need
replacing.
Loose or failed con-
nection.
Sensor gap too
wide
22
Solution
Change rower location to reduce di-
rect exposure to sunlight. Add water
treatment or change tank water as
directed in the water treatment sec-
tion of this manual. Consider using
distilled water to refill tank.
Tighten bungee cord following the
instructions in "reattaching the rower
belt" section of this manual.
Use the back cover of the computer
as a "Gap tool" to check the gap be-
tween sensor head and Magnetic
ring, or see if the Sensor head has
moved out of position.
Please contact your nearest FDF
customer service center for details
Replace/reinstall batteries in correct
position and try again. If the LCD
screen fails to illuminate, try rotating
the batteries slightly in the computer.
If this fails, contact your local service
center.
Check that the computer lead is con-
nected properly. If it is connected
then contact your local service cen-
ter. Check Sensor gap