Troubleshooting - First Degree Fitness Neptune Challenge Owner's Manual

Troubleshooting:

Fault
Water changes color
or becomes cloudy.
Rower belt slipping
off belt/ bungee pul-
ley.
Front leg rises slightly
during vigorous row-
ing
The Neptune Chal-
lenge computer does
not illuminate after
battery installation.
Neptune Challenge
Computer screen
illuminates, but does
not register when
rowing.
12
Probable Cause
Rower is in direct sunlight or
has not had water treatment.
Bungee not under enough ten-
sion.
M10X180mm Vertical Frame
Tensioning Bolt is slightly too
loose.
Batteries installed incorrectly or
need replacing.
Loose or failed connection.
Solution
Change rower location to reduce
direct exposure to sunlight. Add
water treatment or change tank
water as directed in the water
treatment section of this manual.
Tighten bungee cord following the
instructions given in the change
bungee section of this manual.
Tighten bolt 1/2 turn and try
again. Tighten as needed until
problem stops. Note: Over tight-
ening this bolt can damage the
seat rail. Only tighten bolt until
mid leg begins to lift slightly from
the ground. Refer to "Fine Tun-
ing the Neptune Challenge" for
details.
Reinstall batteries in correct posi-
tion and try again. If the LCD
screen fails to illuminate, replace
batteries. If this fails, contact your
local service center.
Check that the computer lead is
connected properly. If it is con-
nected then contact your local
service center.