Address Manager - Dell PowerConnect 3048 User Manual

Link — Shows the status of the link: Up or Down.
l
Admin Enabled — Shows whether a port has been enabled by the network administrator. A network administrator can manually disable a port.
l
State — Describes the state of the port as determined by the Spanning Tree Protocol.
l
Operating Parameters — Allows automatic or manual selection of port speed and duplex mode.
l
Flow Control Enabled — Allows automatic or manual selection of support for flow control.
l
GBIC
The GBIC page allows the user to choose the port type of the gigabit ports. The default is copper. If the user chooses to use a gigabit interface converter
(GBIC), the setting on this page must be appropriately set.
NOTE: This option only applies to the 3024 if 3048 and 3024 are mixed in a stack.
To save any changes you make in this page for the current session, click Apply. To reset these fields to their current value, click Reload.

Address Manager

The Address Manager allows you to manage and view dynamic and static media access control (MAC) addresses as well as set the aging time for dynamic
addresses.
The Address Manager page includes links to the following pages:
Static Addresses
l
Dynamic Addresses
l
Address Aging
l
Static Multicast Group Settings
l