D-Link DIR-822 User Manual page 91

Section 3 - Configuration
Add Wireless The wizard will either display the wireless network settings to
Station:
guide you through manual configuration, prompt you to enter
the PIN for the device, or ask you to press the configuration
button on the device. If the device supports Wi-Fi Protected
Setup and has a configuration button, you can add it to the
network by pressing the configuration button on the device
and then the on the router within 120 seconds. The status
LED on the router will flash three times if the device has been
successfully added to the network.
Add Wireless There are several ways to add a wireless device to your network.
Device Wizard:
A "registrar" controls access to the wireless network. A registrar
only allows devices onto the wireless network if you have
entered the PIN, or pressed a special Wi-Fi Protected Setup
button on the device. The router acts as a registrar for the
network, although other devices may act as a registrar as well.
Click to start the wizard and refer to page 41.
You can also simply press the WPS button on the side of the router, and then
press the WPS button on your wireless client to automatically connect without
logging into the router.
Refer to page 111 for more information.
D-Link DIR-822 User Manual
WPS Button
WPS Button
87