Table of Contents
Advertisement
WANING! DO NOT USE THIS APPLIANCE IF ANY PART HAS BEEN UNDER WATER.
IMMEDIATELY CALL A QUALIFIED SERVICE TECHNICIAN TO INSPECT AND TO REPLACE ANY
PART OF THE ELECTRICAL SYSTEM IF NECESSARY.
· Open the packaging carefully and remove the foam.
· Remove and discard the plastic bag.
· Be responsible when handling the packing materials.
· Keep the original packaging for future transportation and/or storage.
· Check all accessories are removed from the packaging before storing it away for future use.
NOTE: KEEP PLASTIC WRAPPING AWAY FROM CHILDREN!
LOCATING YOUR ELECTRIC FIREPLACE/HEATER
This appliance may be installed virtually anywhere in your home. However, when choosing a location
please ensure that the general instructions are followed. For best results, install out of direct sunlight.
Make sure that the plug or fused spur is accessible after the electric fire is fitted.
Before connecting the appliance make sure that its rating corresponds to that of the mains supply and the
fuse is the correct rating.
The appliance should be located close to a suitable mains socket-outlet to enable connection. The
electrical socket-outlet must be easily accessible to allow disconnection.
NOTE: the appliance is fitted with an inlet plug and socket underneath the right side of the casing.
Always make sure that it is fully pushed in and secure before operating the fire. Damage could
occur if it is not fitted properly.
WARNING! KEEP DRAPERY AND OTHER FURNISHINGS AT LEAST 3'/0.9M FROM THE
FRONT AND SIDES OF THE ELECTRIC HEATER
CLEARANCE TO COMBUSTIBLES
Sides............... 4in. (100mm)
Floor............... 15 3/4 in. (400mm)
Top................. 0 in. (0mm)
Back............... 0 in. (0mm)
INSTALLATION INSTRUCTIONS
Step 1: Using a screwdriver loosen the two screws that secure the wall mounting bracket to the top of the
appliance and remove the wall mounting bracket as shown below (Figure 1).
BFM EUROPE LTD
WALL-MOUNTED ELECTRIC FIREPLACE/HEATER
Page 5
Advertisement
Table of Contents
