Important Instructions - Flavel Onyx MK2 FFHOW0RE2 Instructions Manual

Wall hung electric fires

Hide thumbs

Table of Contents

PLEASE READ THE INSTRUCTIONS CAREFULLY BEFORE INSTALLATION AND/OR

USE OF THIS ELECTRIC FIRE AND RETAIN FOR FUTURE REFERENCE.

WHEN USING ELECTRICAL APPLIANCE, BASIC PRECAUTIONS SHOULD ALWAYS BE

FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND INJURY TO PERSONS,

INCLUDING THE FOLLOWING IMPORTANT SAFETY ADVICE.

READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE.

Regarding installation of the appliance;

· This appliance is supplied with a rewirable plug fitted with

a 13A fuse. Should the fuse or plug need replacing, and

you are competent to do so, it must be replaced with a

13A fuse and the plug muse be a 13amp BS1363A

approved fitted with a 13A fuse.

· Connect this appliance to single-phase AC supply of the

voltage specified on the rating plate.

· This heater must be earthed. If in any doubt consult a

suitable competent person.

· Ensure that the plug socket-outlet connection for this appliance is accessible.

It MUST be readily accessible for easy electrical isolation in the event of servicing and replacing

components etc.

· This appliance MUST NOT be located immediately below an electrical socket-outlet.

· Avoid the use of an extension cord as this may overheat and cause a risk of fire.

· Running this appliance on heat setting 2 (1800W) with another piece of electrical equipment on the

same circuit may cause the fuse of this appliance to blow, or your circuit breaker to turn off the power

supply. If this occurs reconnect one of the appliances to another circuit.

· This appliance is fitted with an automatic thermal cut out to reduce the risk of damage in the event of

abnormal operation e.g. when covered. If the heater stops operating whilst the flame effect continues

normally this indicates that the cut out is in operation. If this occurs disconnect the power supply at the

plug socket-outlet and ensure that any obstructions to the fan heater outlet or fan blades etc. are

removed. The heater will automatically reset when cool enough. The thermal cut out WILL NOT

RESET unless the obstruction is removed and the appliance cools. If the heater is still not operating

after 10 minutes disconnect the appliance and seek expert advice.

· If the supply cord is damaged it must be replaced by the manufacturer, its service agent or a similarly

qualified person in order to avoid a hazard. The cable used MUST be capable of handling 2.5kW of

power at 240V and MUST contain an earth wire.

· To completely shut this appliance off turn all the controls to OFF and remove the plug from the socket-

outlet.

· Use the heater in a well-ventilated area.

Regarding persons operating the appliance;

· This appliance is not intended for use by persons (including children) with reduced physical, sensory or

learning disabilities, or lack of experience and knowledge, unless given supervision or instruction

concerning use of the appliance by a person responsible for their safety.

· Children should be supervised at all times to ensure that they do not play with the appliance.

· Extreme caution is necessary when any heater is used by or near children, invalids or elderly persons

and whenever the heater is left operating and unattended.