Haier HCW3485AES User Manual page 44

Cooling fan continues
to run after oven is
turned off
Oven door is locked
and will not release,
even after cooling
Oven is not heating
Oven is not cooking
evenly
Oven temperature is
too hot or too cold
Oven light is not
working properly
Oven light stays on
Cannot remove lens
cover on light
Oven will not Self-
Clean properly
Clock and timer are
not working properly
Excessive moisture
Porcelain chips
FOR MORE HELP, VISIT HAIER.COM OR CALL THE CONSUMER
HELP LINE AT 1-877-377-3639.
42
The fan turns off automatically when the electronic
components have cooled sufficiently.
Turn the oven off at the circuit breaker and wait a few
seconds. Turn breaker back on. The oven should reset
itself and will be operable.
Check the circuit breaker or fuse box to your house. Make
sure there is proper electrical power to the oven. Make
sure the oven temperature has been selected.
Check oven calibration. Adjust calibration if necessary
(see To Set Temperature). Refer to cook charts for
recommended rack position. Always reduce recipe
temperature by 25 °F (15 °C) when baking with
Convention Bake mode.
The oven thermostat needs adjustment. See Calibrating
Oven Temperature.
Replace or reinsert the light bulb if loose or defective.
Touching the bulb with fingers may cause the bulb to burn
out.
Check for obstruction in oven door. Check to see if hinge
is bent or door switch broken.
There may be a soil build-up around the lens cover. Wipe
lens cover area with a clean dry towel prior to attempting
to remove the lens cover.
Allow the oven to cool before running Self-Cleaning.
Always wipe out loose soils or heavy spillover before
running Self-Cleaning. If oven is badly soiled, set oven
for a four-hour Self-Cleaning. See Preparing the Oven to
Self-Clean.
Make sure there is proper electrical power to the oven.
See the Clock and Timer sections.
When using bake mode, preheat the oven first.
Convection Bake and Convection Roast
any moisture in oven (this is one of the advantages of
convection).
When oven racks are removed and replaced, always tilt
racks upward and do not force them to avoid chipping the
porcelain.
will eliminate