Setting The Self-Clean Mode - Haier HCW3485AES User Manual

SETTING THE SELF-CLEAN MODE

TO SET THE SELF-CLEAN MODE
1. Touch [UPPER/LOWER] key to select the cavity to be cleaned, if the oven is a
double.
2. Rotate both knobs into the clean position.
3. CLEAN & TIME appear.
4. The clean time is displayed automatically, its standard value is 3 hours.
5. At the end of the programmed cleaning time, the oven will automatically turn off.
6. To stop the cleaning mode at any moment, move one of the two knobs from the
cleaning position.
Do not attempt to open the door while the door is locked. The "AUTO LOCK"
writings will flash until the motor stops. When they are displayed, the door cannot be
opened. Check that the door has been locked and will not open before starting the
Self-Clean mode.
If door does not lock, rotate the cooking mode knob into the OFF position and do
not start self-clean; phone for service.
If the door is in the open position when this mode is selected, the "AUTO LOCK"
writings will flash until the door is closed. The latch doesn't move.
TO CHANGE THE CLEANING TIME
1. To change the setting from 3 hours, select either 2 hours for light soil or 4 hours
for heavy soil immediately before starting.
2. To change the hours, touch the [TIME] key.
3. The hours will flash.
4. Use [INC] or [DEC] keys to change the value
5. To change the minutes, touch the [TIME] key again.
6. The minutes will flash.
7. Use [INC] or [DEC] keys to change the value. Hold the key to change by 10
minutes steps.
8. Touch [TIME] or wait a few seconds to confirm the new value.
34