Displayer Resolution Adjustment - eLine ELI-SIP-NVR4-POE Manual

Figure 4-8 Shutdown interface

4.8 Displayer resolution adjustment

NVR support resolutions with VGA 1024*768, VGA 1280*1024, VGA1600*1200,
HDMI720P, HDMI1080P, you can select the proper resolution according your
displayer.
For display using VGA set to 1024*768 or VGA 1280*1024. When using HDMI input we
advise to use HDMI 1080P.
Adjustment Steps:
Step 1
Click Change on login interface and find the adjustment interface shown in Figure 4-9.
12
Figure 4-9 Adjust displayer
Step 2
Choose the type of resolution in the resolution of the drop-down box.
Device will automatically switch to the selected resolution and show the dialog for Yes
or Cancel.

If no operate in 10 seconds, displayer will back to previous resolution.

If select Yes then will switch to the selected resolution.

If select cancel display will not save the configuration and back to previous
resolution.
Step 3
Adjust display.
If displayer couldn't show the full screen (at the corners can't see
adjust the displayer (we advise to auto adjust first)
1. Click Adjustment button at lower right corner.
2. In the step of the drop-down box to choose the adjustment step.
Step: The moving distance when adjust screen each times , the greater number the
more moving distance, you can select the larger step sizes to adjust sketchy, and
then select the smaller step tuning.
3. Use UP, DOWN, LEFTRIGHT button to adjust the screen.
Step 4
Click the configuration interface
Exist displayer interface
Back to Login interface
) then we need to
to close.
13