eLine ELI-SIP-NVR4-POE Manual page 23

Step 38 Enable the record
(Enable as Default)
Step 39 Please select "√" on the cameras which you want to record, and also select the
corresponding streams parameters.
Step 40 Click to More
Call the record policy configuration interface like Figure 4-35.
Figure 8-11 Record Policy Configuration
Figure 4-35 Schedule record configuration interface.
Step 41 Configure Record Policy
Configure 7*24H and Record by Schedule two policies.
If select record by schedule, we need to configure the schedule plan. Steps as below
22. Click , enter into the schedule record configure interface, like Figure 4-36.
23. Configure the schedule for recording.
24. Click Apply to save.
40
Figure 4-36 Schedule record configuration
Step 42 Whether to enable the alarm record

If not want to enable the alarm record, then just set the button to OFF.

If want to enable the alarm record, then set the button to ON.
Step 43 Whether to enable the audio
Step 44 Configure the Storage Policy
Storage Policy you can select:

When HDD is full, record cycle.

Retention day time.
Step 45 Configure the HDD disk group.
There will be 2 HDD disk groups. We can set the recording to be recorded into two
different HDD disk groups.
Step 46 Configure the record streams bit rates.
Step 47 Click Apply to save the configurations and exit the record policy interface.
-
41