First Boot; Shutdown - eLine ELI-SIP-NVR4-POE Manual

No. Name
8 RST button
9 GND connect
10 DC48V Power
interface

4.6 First boot

 Make sure that the right of access to power NVR.
 Ensure correct display HDMI or VGA interface connection is set from switch
If the front panel of the power indicator lamp does not flash please plug in the power
cable .Enable the power switch, NVR start running. If the front panel power indicator
lamp flashing Red light, please put the switch at front panel to start device. Note: If
want to use POE power supply, please plug in the DC48V power adapter.
After the device starts, the power light is solid red device starts after the self-test, and
the test results are displayed on the screen. Show in Figure 4-7. Entire boot process
takes about two minutes.
Figure 4-7 Device power on
Description
Restores the factory default settings. 5 second holds
GND connect
DC48V.1.04A power input
10
When an exception occurs when the device self-test, this interface will stay in the lower
right of the screen, you can choose to continue or shutdown. If you choose to continue,
the device will continue to start, until the device login screen is shown.
NVR hard drive has rigorous testing, if fails, the reasons may include the following：

Unformatted new hard disk. Go to quickly configure the hard disk is formatted。

Formatted hard drive, the NVR supported file systems do not match。

Hard disk is damaged。

4.7 Shutdown

If the equipment is not load, long press the PWR button on the front panel for more
than three seconds, the device will shut down, solid red becomes off after a
successfully shut down.

Shutdown process, the system prompts are off, do not cut off the power。
 Equipment running directly through the rear panel power off switch, cut off the
power or unplug the power cord should be avoided.
 In some circumstances, the power supply is not normal, will lead to the NVR not to
work properly, serious damage can occur to the NVR. In this environment, it is
recommended to use regulated power supply, or a backup AC source.
 If the device is logged into the main interface, you can click the top right
Button or long press the PWR button on the front panel for more than three seconds
will bring up the shutdown interface, shown in Figure 4-8 Interface.
11