Troubleshooting - REI ECD-5500 Installating And Operation Manual

TROUBLE SHOOTING
Problem
Backlighting is on, but no LCD display
Cannot tune radio stations
USB media not playing, or says loading.
Audio is distorted or low.
iPod® screen displays "loading" for a
long period of time.
The Radio does NOT respond to the front
buttons
The Radio does not charge my device
Cause
No power to BATTERY wire or blown 10A
main fuse.
The antenna cable is not connected. The signal
is too weak. The radio is in the wrong
frequency steps.
Media is the wrong file type.
Source audio level is too weak or overdriven.
Bitrate of audio file is too large.
Device is not a supported device. The radio
supports a majority of iPod® models, but not all
are guaranteed.
An error in operation has occurred
The device requires additional current via the
USB to charge the device
17
Solution
Check for both ACC & BATTERY voltage
with Multi-meter, check all fuses.
Connect the antenna cable. Check the
frequency spacing in the radio's SERVICE
menu.
Convert files to a usable format, see file
requirements section of the manual.
Adjust the volume level of the auxiliary
source. Change the sample frequency or
Bitrate of the file.
Wait for iPod® to load or reconnect 30-pin
plug. If still loading, then device is not
supported, or has low battery. Use the
AUX input or a Bluetooth® connection
instead.
Reset the unit from the front panel.
Unplug and try again. The USB cannot
support more than 5V/500mA.