Heavy duty am/fm stereo weather band radio, usb ipod control and charging, bluetooth hands free calling and wireless audio streaming, front/rear auxiliary inputs and built in pa (13 pages)
Page 1
Frequency Response (+/- 1db) 20HZ – 20Khz Input Voltage Maximum Voltage 1200mV Input impedance 10KΩ Radio Engineering Industries, Inc. Radio Engineering Industries, Inc. 6534 “L” Street Omaha, Nebraska 68117 Phone: 402-339-2200 Toll-Free 1-800-228-9275 www.radioeng.com Rev 0.2 02-28-13 Installation/Operation Manual 50W x 4 CD-3000...
Thank you for purchasing the CD-3000 AM/FM/CD/MP3/USB/SD Receiver from REI. SPECIFICATIONS: This product is designed and tested to withstand temperature and vibration extremes. General Specifications Please read the owner’s manual carefully before attempting to install. Operating Voltage (10.0 –15.6V allowable)
RADIO REMOVAL To remove the radio, disconnect the rear support stud if installed. Carefully release the front Trim Ring lock tabs at the top and bottom of the nosepiece. Then insert the two release keys on both sides of the nosepiece and pull the radio out. CONTROLS AND INDICATORS Power Button TROUBLESHOOTING...
REQUIRED RADIO DIMENSIONS OPERATION Verify the radio will fit by following the suggested dimensions below. 1) Power Button Press the Power Button to turn ON or OFF the unit. A red light means the unit is in standby, a Blue light means the radio is on. 2) Volume/Select Knob Rotate the knob left or right to change the volume level.
8) Mute Button RADIO CONNECTIONS Press this button to mute the source audio. Follow this easy wiring diagram when installing. Be sure to disconnect the battery negative terminal before beginning. 9) TUNE / SEEK /TRACK Buttons Under Radio mode, press the desired button to manually tune a station moving upward or downward.
PA OPERATION The CD-3000 has three PA Microphone inputs, 2 Dynamic & 1 Carbon microphone input. All microphones have priority over all other audio modes and MUTE the source audio being played when keyed. When the PA is triggered, the front display will show MIC 1, MIC 2 or MIC, until the trigger is un-keyed.