Display Information; Removing The Control Panel From The Boiler; Display Readings - Worcester GB162-50 Installation And Servicing Instructions

14

Display information

This section describes how to read operating and fault messages from
the BC10 basic controller and what they mean.
For exact troubleshooting instructions please refer to
the boiler service instructions. You may also contact
Worcester technical support (0330 123 3366)
14.1

Removing the control panel from the boiler

To make it easier to use the buttons on the control panel when the boiler
door is open and to make it easier to read out the values in the display,
you can disassemble the control panel from the boiler door and hang it
from the boiler frame.
▶ Open the boiler door ( fig. 38 "Opening the boiler door", page 26).
▶ Undo the 2 screws of the control panel at the back of the boiler door
[1].
1
Fig. 119 Undoing the screws
▶ Undo the cable tie [1].
▶ Remove the control panel.
Fig. 120 Removing the control panel
[1] Cable tie
6720813171 (2015/04)
▶ Use the 2 hooks to hang the control panel from the boiler.
Fig. 121 Hanging the control panel from the boiler frame
14.2
Display
reading Key to display reading
[\/2/4|
[p/1.6|
1
Table 22 Display readings
6 720 648 726-120.1TD
1
6 720 648 726-121.1TD

Display readings

Current CH flow temperature.
Current system pressure.
Display information
6 720 648 726-122.1TD
Unit Range
[\/\/0| – [1/3/0|
°C
[p/0.0| – [p/4.0|
bar
53