Advertisement
Burner Installation
1. Remove both accent light assemblies from the brackets at the rear of the firebox (save the screws).
Place the accent light assemblies in the center of the firebox floor, as shown below.
NOTE: Do not touch the bulbs.
Figure 2: Accent light bracket screws location
2. Install the intake restrictor as shown below, using the existing screws on the rear wall of the firebox.
Set the intake restrictor to the correct setting for the vent configuration. See the installation manual for
details.
Page 3 of 11
564 HO DancingFyre Burner
Installation Instructions
Figure 3: Accent lights placed on firebox floor
Figure 4: Intake restrictor installed, showing location of screws
17601661 — 9/22/11
(sku: 96900114)
© Travis Industries, Inc.
Advertisement
