Comfort Glow CF26PR Owner's Operation And Installation Manual page 10

VENT-FREE PROPANE/LP BAY FRONT FIREPLACE
INSTALLATION
Continued
INSTALLING BLOWER
ASSEMBLY - GA3450T
Note: If you are using a mantel with your
heater, use the following instructions. If
your heater is built-in, see For Built-In In-
stallation on page 11.
1. Screen and hood should be removed
from fireplace (see page 9). Remove
log set and set aside.
2. Install snap bushings found in hardware
kit into both holes in rear of blower
control shield (see Figure 15).
3. Make sure the wire harness is firmly
connected to the terminals on the blower
bracket assembly.
4. Note the wire locations on back of
AUTO/OFF/ON switch. Carefully re-
move red wire from the AUTO termi-
nal and blue wire from the ON termi-
nal. Black wire can remain on the
middle or OFF terminal (see Figure 16).
5. Carefully disconnect green and white
wires from power cord harness at their
insulated connectors.
6. In top of the heater cabinet, locate the
four mounting holes on the outer cas-
ing. Align these four holes with those
on the blower bracket assembly. Attach
blower bracket assembly to the outer
casing with 4 - #10 screws provided
(see Figure 16).
7. Route the wire harness through the hole
to the left side of heat deflector. Pull
wire harness through lower opening to
the left of the blower control shield. (see
Figure 16).
8. Insert the 4 wire harness into one of the
round holes in the rear of the blower
control shield and through the rectan-
gular hole in the front of shield (see
Figure 16).
9. Reconnect red wire to the AUTO switch
position. Reconnect blue wire to the ON
switch position. Reconnect green and
white wires to the power cord.
CF26PR
10. Install the switch plate on the blower
control shield with 2 - #10 screws pro-
vided (see Figure 17). Route power cord
out of the cabinet by inserting it through
the bushing on the outer casing (see Fig-
ure 16). Plug fan kit into 120-Volt
grounded power supply and test opera-
tion. Note: When switch is in the AUTO
Blower
Control
Shield
Figure 15 - Installing Snap Bushings
Blower Bracket
Assembly
Screw
Switch
Blue
Switch Plate
Blower
Control
Shield
Figure 16 - Installing Blower Bracket Assembly
Blower
Control
Shield
Switch
Plate
Screw
Figure 17 - Installing Switch Plate to Blower Control Shield
11. Place log set back on the unit.
Snap
Bushing
Wire Harness
Power
Cord
Red
Wire
Harness
Shield Cover
10
position, the fan will start after the heater
has run for a few moments. The fan will
continue to run for several moments af-
ter the heater has been turned off. When
switch is in the ON position, the fan will
run until turned to OFF. Reinstall hood
assembly and close lower louver door.
Wiring Routing Hole
Heat
Deflector
105442