Table of Contents
Advertisement
Quick Links
VENTED DECORATIVE APPLIANCES
OWNER'S OPERATION AND INSTALLATION MANUAL
Convertible from Natural Gas to Propane/LP Gas
Z21.60-1996
CGA 2.26-M96
APPROVED
®
WARNING: If the information in this manual is not
followed exactly, a fire or explosion may result
causing property damage, personal injury, or
loss of life.
— Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
— WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use
any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call
the fire department.
— Installation and service must be performed by
a qualified installer, service agency, or the
gas supplier.
WARNING: This is a gas-fired appliance. It uses air (oxygen) from the room in which
it is installed. Provisions for adequate combustion and ventilation air must be
provided. Refer to Air for Combustion and Ventilation section on page 4 of this manual.
GAS LOG
REMOTE READY
Save this manual for future reference.
Models CPVSA18R,
CPVSA24R, CVDA18R,
CVDA24R, and CVDA30R
WARNING: Improper installa-
tion, adjustment, alteration, ser-
vice, or maintenance can cause
injury or property damage. Re-
fer to this manual for correct
installation and operational
procedures. For assistance or
additional information consult
a qualified installer, service
agency, or the gas supplier.
WARNING: This appliance is
for installation only in a solid-
fuel burning masonry or UL127
factory-built fireplace, con-
structed of noncombustible
material, and connected to a
working flue. (See page 7 for
minimum flue opening.)
Advertisement
Table of Contents
Related Manuals for Comfort Glow CPVSA18R
Summary of Contents for Comfort Glow CPVSA18R
- Page 1 VENTED DECORATIVE APPLIANCES OWNER’S OPERATION AND INSTALLATION MANUAL Convertible from Natural Gas to Propane/LP Gas Z21.60-1996 CGA 2.26-M96 APPROVED Models CPVSA18R, CPVSA24R, CVDA18R, CVDA24R, and CVDA30R ® WARNING: Improper installa- WARNING: If the information in this manual is not tion, adjustment, alteration, ser-...
-
Page 2: Safety Information
VENTED GAS LOGS SAFETY If you smell gas 11. Do not run log set • shut off gas supply • where flammable liquids or vapors INFORMATION • do not try to light any appliance are used or stored • do not touch any electrical switch; do •... -
Page 3: Product Identification
OWNER’S MANUAL PRODUCT LOCAL CODES IDENTIFICATION Install and use log set with care. Follow all local codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code ANS Z223.1, also known as NFPA 54*. *Available from: Grate Steps American National Standards Institute, Inc. -
Page 4: Air For Combustion And Ventilation
VENTED GAS LOGS AIR FOR PROVIDING ADEQUATE Confined and Unconfined Space VENTILATION COMBUSTION AND The National Fuel Gas Code (ANS Z223.1, 1992 Section 5.3) defines a confined space The following are excerpts from National VENTILATION as a space whose volume is less than 50 Fuel Gas Code. - Page 5 OWNER’S MANUAL AIR FOR COMBUSTION AND VENTILATION Continued DETERMINING FRESH-AIR FLOW FOR APPLIANCE LOCATION Determining if You Have a Confined or Unconfined Space Use this work sheet to determine if you have a confined or unconfined space. Space: Includes the room in which you will install appliance plus any adjoining rooms with doorless passageways or ventilation grills between the rooms.
- Page 6 VENTED GAS LOGS AIR FOR COMBUSTION AND 12" VENTILATION Continued Ventilation VENTILATION AIR Ventilation Grills Grills Into Adjoining Room, Into Adjoining Ventilation Air From Inside Option 2 Room, Remove Building Option 1 Door into This fresh air would come from an adjoining Adjoining unconfined space.
-
Page 7: Installation
OWNER’S MANUAL INSTALLATION Btu Input Btu Input MODEL DESCRIPTION Natural Gas Propane/LP Gas CPVSA18R 18" Single Burner 50,000 40,000 CAUTION: Do not remove the metal data plates attached CPVSA24R 24" Single Burner 60,000 50,000 to the burner pan. The data plates CVDA18R 18"... -
Page 8: Connecting To Gas Supply
VENTED GAS LOGS INSTALLATION CHECKING GAS CAUTION: Use only new, CONNECTIONS Continued black iron or steel pipe. Inter- nally-tinned copper tubing may INSTALLING DAMPER WARNING: Test all gas pip- be used in certain areas. Check CLAMP ing and connections for leaks your local codes. - Page 9 OWNER’S MANUAL INSTALLATION Place burner manifold in pan with Install the inlet fitting into the inlet opening of the gas control valve (see threaded opening facing open knock-out Continued plug (see Figure 9). Note: If using pro- Figure 12). Use thread sealant on the pane/LP gas, see Propane/LP Gas Con- male pipe threads.
- Page 10 VENTED GAS LOGS INSTALLATION Propane/LP Gas Conversion Adjusting Regulator Pressure For Propane/LP Conversion Continued To convert to propane/LP gas, the regulator 1. Locate the pressure button on regula- pressure must be reset. Also, the burner inlet 13. Install cover to burner pan using screws tor tower of gas control valve.
-
Page 11: Remote Control Options
OWNER’S MANUAL INSTALLATION REMOTE CONTROL OPTIONS No Optional Accessories Continued If you choose no remote accessories at this CGHRC time, the provided jumper wire must be Changing Pilot Orifice If you are using the CGHRC remote control installed to the terminal block on the gas option, you must first connect the leads of control. -
Page 12: Operating Appliance
VENTED GAS LOGS INSTALLATION OPERATING Continued APPLIANCE ADDING PAN MATERIAL FOR YOUR SAFETY Open the bag of ash bed material (ver- READ BEFORE miculite) and spread it evenly across the LIGHTING burner pan to the top. You may over- flow the front and sides of the pan to WARNING: If you do not fol- cover the entire pan. -
Page 13: Lighting Instructions
OWNER’S MANUAL OPERATING 8. Keep control knob pressed in for 30 TO TURN OFF GAS seconds after lighting pilot. After 30 TO APPLIANCE APPLIANCE seconds, release control knob. • If control knob does not pop out when Shutting Off Appliance Continued released, contact a qualified service Slightly push in and turn control... -
Page 14: Optional Remote Operation
VENTED GAS LOGS OPERATING OPTIONAL REMOTE OPERATION APPLIANCE Note: All remote control accessories must Continued be purchased separately. Follow instruc- tions included with the remote control. CURING LOGS NOTICE: You must light the pilot before using the hand-held re- During the 2-3 hour appliance break-in mote control unit. -
Page 15: Troubleshooting
OWNER’S MANUAL TROUBLESHOOTING WARNING: Turn off log set and let cool before servicing. Only Note: For additional help, visit DESA a qualified service person should International’s Technical Service web service and repair log set. site at www.desatech.com. Note: All troubleshooting items are listed in order of operation. - Page 16 VENTED GAS LOGS TROUBLESHOOTING Continued OBSERVED PROBLEM POSSIBLE CAUSE REMEDY When ignitor button is pressed, there is no 1. Ignitor electrode not connected to igni- 1. Reconnect ignitor cable spark at pilot tor cable 2. Ignitor cable pinched or wet 2.
- Page 17 OWNER’S MANUAL TROUBLESHOOTING Continued WARNING: If you smell gas • Shut off gas supply. • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
-
Page 18: Illustrated Parts Breakdown
VENTED GAS LOGS ILLUSTRATED PARTS BREAKDOWN MODELS CVDA18R, CVDA24R, CVDA30R 901271... -
Page 19: Parts List
OWNER’S MANUAL PARTS LIST This list contains replaceable parts used in your log set. When ordering parts, follow the instructions listed under Replacement Parts on page 22 of this manual. MODELS CVDA18R, CVDA24R, CVDA30R PART NUMBER FOR CVDA18R CVDA24R CVDA30R DESCRIPTION QTY. - Page 20 VENTED GAS LOGS ILLUSTRATED PARTS BREAKDOWN LOG SET MODELS CPVSA18R, AND CPVSA24R 901271...
- Page 21 OWNER’S MANUAL PARTS LIST This list contains replaceable parts used in your log set. When ordering parts, follow the instructions listed under Replacement Parts on page 22 of this manual. LOG SET MODELS CPVSA18R, AND CPVSA24R PART NUMBER FOR CPVSA18R...
-
Page 22: Cleaning And Maintenance
VENTED GAS LOGS CLEANING AND ACCESSORIES DECORATIVE ASH BED CONTROL COVER - CDABK MAINTENANCE Purchase these log set accessories from your (Not Shown) local dealer. If they can not supply these • Keep the area around the log set clean An attractive way to cover control knob accessories, call DESA International’s Sales and clear of debris. -
Page 23: Parts Centrals
OWNER’S MANUAL PARTS CENTRALS These Parts Centrals are privately-owned businesses. They have agreed to support our customer’s needs by providing original replacement parts and accessories. Baltimore Electric Four Flags Power Products East Coast Energy Products Halco Enterprises 1348 Dixwell Avenue 1115 Stateline Road 707 Broadway 208 Carter Drive, Unit 21... -
Page 24: Warranty Information
We make no other warranty, expressed or implied. LIMITED WARRANTY COMFORT GLOW VENTED GAS LOGS DESA International warrants this product to be free from defects on burner system for three (3) years, gas control for one (1) year, and logs for a lifetime from the date of first purchase, provided that the product has been properly installed, operated and maintained in accordance with all applicable instructions.