Beeper Definitions - Datalogic QD 2300 QuickScan L Quick Reference Manual

Beeper Definitions

The scanner issues different beep sequences and patterns to indi-
cate status. The table below defines beep sequences that occur dur-
ing both normal scanning and while programming the scanner.
Beeper Sequence
Standard Use
L
ow/medium/high beep
Short high beep
4 long low beeps
5 low beeps
Low/high/low beep
High/high/high/
low beep
Parameter Menu Scanning
Short high beep
Low/high beep
High/low beep
High/low/high/
low beep
Low/high/low/
high beep
Code 39 Buffering
High/low beep
3 beeps - long high beep
Low/high/low beep
6
Indication
Power up.
A barcode label was decoded (if decode
beeper is enabled).
A transmission error was detected in a
scanned barcode. The data is ignored.
This occurs if a unit is not properly con-
figured. Check option setting.
Conversion or format error.
ADF transmit error.
RS-232 receive error.
Correct entry scanned or correct menu
sequence performed.
Input error, incorrect barcode or Cancel
scanned, wrong entry, incorrect barcode
programming sequence; remain in pro-
gram mode.
Keyboard parameter selected. Enter
value using barcode keypad.
Successful program exit with change in
the parameter setting.
Out of host parameter storage space.
Scan SET DEFAULTS on page
New Code 39 data was entered into the
buffer.
Code 39 buffer is full.
The Code 39 buffer was erased or there
was an attempt to clear or transmit an
empty buffer.
10.
TM
QuickScan L