Bluetooth Bar Code Reader Setup - Honeywell MX8 Reference Manual

Bluetooth Bar Code Reader Setup

Please refer to the mobile Bluetooth scanner manufacturer's User Guide; it may be available on the manufacturer's web site.
This section describes the interaction and setup for a mobile Bluetooth laser scanner or laser imager connected to the MX8
using Bluetooth functions.
The MX8 must have the Bluetooth hardware and software installed. An MX8 operating system upgrade may be required.
l
If the MX8 has a Bluetooth address identifier bar code label affixed, then Bluetooth hardware and software are installed.
l
The mobile Bluetooth laser scanner / laser imager battery is fully charged.
l
The MX8 batteries are fully charged. Alternatively, the MX8 may be cabled to AC/DC power.
l
Important: The bar code numbering examples in this segment are not real and should not be created or scanned with a
l
Bluetooth scanner.
To open the EZPair program, tap Start > Settings > System > Bluetooth or tap the Bluetooth icon at the bottom of the
l
Today screen.
Locate the bar code label, similar to the one shown above, attached to the MX8. The label is the Bluetooth address identifier for
the MX8.
The mobile Bluetooth scanner / imager requires this information before discovering, pairing, connecting or disconnecting can
occur.
Note: The MX8 Bluetooth address identifier label should be protected from damage (rips, tears, spills, soiling, erasure, etc.)
at all times. It may be required when pairing, connecting, and disconnecting new Bluetooth bar code readers.
4-83