Honeywell MX8 Reference Manual page 103

Message
Read registry failure-Cmd AppCommandLine registry entry is missing or empty. This is not considered an error since command line
Line information is not necessary to launch and lock the application.
Read registry failure- The Internet registry entry is missing or empty. This is not considered an error since the Internet value is not
Internet necessary to launch and lock the application.
Registering Backdoor The AppLock system communicates with the keyboard hook via a user defined message. Both AppLock.exe
MSG and Kbdhook.dll register the message at initialization.
The AppLock system communicates with the keyboard hook via a user defined message. Both Applock.exe
Registering Hotkey MSG
and Kbdhook.dll register the message at initialization.
The registry has to be read when entering user mode is the AppName is missing. This user mode entry is
Registry read failure at
attempted at boot and after a hotkey switch when the administrator has closed the application being locked or
reenter user mode
has changed the application name or command line.
The registry has to be read when switching into user mode. This is because the administrator can change the
Registry read failure at
settings during administration mode. The read of the registry failed which means the Administration key was
reenter user mode
not found or the AppName value was missing or empty.
The registry read failed. The registry information read when this message is logged is the application
information. It the Administration key cannot be opened or if the AppName value is missing or empty, this error
Registry read failure
is logged. The other application information is not required. If the AppName value is not available, AppLock
cannot switch into user mode.
Reset system work area The system work area is adjusted when in user mode to cover the taskbar area. The system work area has to
failure be adjusted to exclude the taskbar area in administration mode. AppLock was unable to adjust this area.
Shift pressed The Shift key has been pressed and trapped by the HotKey processing.
Shift Processing the hotkey and backdoor entry
Show taskbar The taskbar is now being made visible and enabled.
Switching to admin- The system is currently in user mode and is now switching to admin mode. The switch occurred because of the
backdoor backdoor key presses were entered by the administrator.
Switching to admin-hotkey The system is currently in user mode and is now switching to admin mode. The switch occurred because of a
press hotkey press by the administrator.
Switching to admin- The keyboard hook load failed, so AppLock switches to admin mode. If a password is specified, the password
kbdhook.dll not found prompt is displayed and remains until a valid password is entered.
Switching to admin-
If the keyboard hook initialization fails, AppLock switches to admin mode. If a password is specified, the
keyboard hook
password prompt is displayed and remains until a valid password is entered.
initialization failure
Switching to admin- See the explanation of the "Registry read failure" above. AppLock is switching into Admin mode. If a password
registry read failure has been configured, the prompt will be displayed and will not be dismissed until a valid password is entered.
Switching to
In administration mode, the taskbar is visible and enabled.
TaskbarScreenMode
Switching to user mode The registry was successfully read and AppLock is starting the process to switch to user mode.
Switching to user-hotkey The system is currently in admin mode and is now switching to user mode. The switch occurred because of a
press hotkey press by the administrator.
Explanation and/or corrective action Level
LOG_ERROR
LOG_ERROR
LOG_
PROCESSING
LOG_
PROCESSING
LOG_ERROR
LOG_ERROR
LOG_ERROR
LOG_ERROR
LOG_EX
LOG_EX
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_EX
LOG_
PROCESSING
LOG_
PROCESSING
4-65