Table of Contents
Advertisement
Operating Instructions
• D-ZOOM RATIO: Set the D-Zoom Ratio from DX 1.1~DX5.0
• STAYING ZOOMING : Sets the duration time for preset zoom area.
CAUTION
• Set the direction of video by MIRROR/FLIP before POINTING ZOOM setting.
Otherwise location of zoom center could be different from your intention.
• Preset Zoom is available with RS-485 model only.
9. SYSTEM
SYSTEM
TV SYSTEM
RESOLUTION
COMM. SETUP
UTC CONTROL
LANGUAGE
OUTPUT SELECT
FACTORY DEFAULT
RETUTN
9-1. TV SYSTEM
(default: US or EU)
: Selects HDTV standards for US(60HZ) or EU(50HZ). By this selection, 2nd
analog video output switches to NTSC or PAL accordingly.
9-2. RESOLUTION
(default: 1080P)
: Three resolutions,1080P/720P(SCALED)/720P(CROPPED) are available.
1080P outputs 1920x1080 video at the frame rate of 30P/25P.
• 720P(SCALED): Image is scaled down from 1080P and outputs 1280x720
video without loss of field of view at the frame rate of 30P/25P.
• 720P(CROPPED): Image is cropped at the center area from the image sensor
and outputs 1280x720 at the frame rate of 30P/25P.
Cropped image has narrowed field of view.
9-3. COMM. SETUP
: COMM. SETUP defines the CAM ID, BAUD RATE and PROTOCOL.
Data length, stop bit and parity are fixed to 8bit, 1stop bit and no parity bit.
• CAM ID – Assigns the camera ID from 1~255 for the comm. address.
• BAUD RATE – Select the baud rate from 2400~115200.
• PROTOCOL – Select the comm. Protocol from PELCO-D/P or VISCA.
US(NT)
1080P
PELCO-C
ENG
TVI
NO
RET
18
Advertisement
Table of Contents
