Adjusting The Display Contrast; Setting The Peak Hold Time; Setting Trim Operation Mute; Making Power Management Settings - Tascam DR-701D Reference Manual

Adjusting the display contrast

While pressing and holding the MENU button, turn the DATA
dial to adjust the display contrast.

Setting the peak hold time

You can set the level meter peak hold time.
1. On the page, select the
METER/TRIM
item. (see "Menu operation procedures" on page 12)
2. Set the level meter peak hold time.
Options: , ,
OFF 1sec 2sec
(always shown)
3. When finished, press the MENU button to return to the
Home Screen.
NOTE
When the Home Screen is open, turn the DATA dial to reset
peak hold display.

Setting trim operation mute

You can set whether or not minimizing the 1/2/3/4 knob values
mutes or not when the Home Screen is in trim display mode.
1. On the page, select the
METER/TRIM
(see "Menu operation procedures" on page 12)
2. Set the trim curve.
Option Meaning
Minimizing the 1/2/3/4 knob values
MIN
does not mute.
Minimizing the 1/2/3/4 knob values
(default)
MUTE
mutes.
3. When finished, press the MENU button to return to the
Home Screen.
PEAK HOLD
(default), ,
10sec HOLD
item.
TRIM MIN
9 – Settings and Information

Making power management settings

You can make various power management settings on the
page.(see "Menu operation proce-
POWER MANAGEMENT
dures" on page 12)

Setting the type of batteries

Use the item to set the type of batteries
BATTERY TYPE
used. This setting is used to show the amount of remaining
battery charge and determine if the unit has enough power for
normal operation.
Options: (alkaline, default),
ALKALI
hydride), (lithium)
LITHIUM

Set the automatic power saving function

Use the
AUTO PWR SAVE
from when the unit last operated or was used until the unit
automatically turns off (enters standby).
Options: (unit does not automatically turn off ),
OFF
, ,
5min 10min 30min

Setting the backlight

Use the item to set the time until the backlight
BACKLIGHT
automatically dims after the last operation when powered by
batteries.
Options: (unlit),
OFF 5sec
, (always stays lit)
30sec ALWAYS

Restoring factory default settings

You can restore the various settings stored in the backup
memory of the unit to their factory default values.
1. On the page, select the
SYSTEM
"Menu operation procedures" on page 12)
2. Press the DATA dial.
A confirmation pop-up message appears.
3. Press the DATA dial to initialize the unit.
Press 1/8 to cancel starting initialization.
(nickel-metal
Ni-MH
item to set the amount of time
3min
(default)
(default), , ,
10sec 15sec
item. (see
INITIALIZE
37
TASCAM DR-701D
,