Table of Contents
Advertisement
D-Fi 2.4 GHz
(DMX Mode
Manual Sync)
Freedom Par Quad-4 IP User Manual Rev. 3
The Freedom Par Quad-4 IP series offers wireless control of 2 or more products with a
single DMX controller. To manually set up the D-Fi 2.4 GHz syncing for DMX, do the
following.
For the transmitting product:
1.
Press <MENU> repeatedly until S-tr shows on the display.
2.
Press <ENTER>.
3.
Press <UP> or <DOWN> until dtCH appears on the display.
4.
Press <ENTER>.
5.
Use <UP> or <DOWN> to select the transmitting signal (dt 1–dt16).
For the receiving product(s):
1.
Press <MENU> repeatedly until S-tr shows on the display.
2.
Press <ENTER>.
3.
Press <UP> or <DOWN> until drCH appears on the display.
4.
Press <ENTER>.
5.
Use <UP> or <DOWN> to select the receiving signal (dr 1–dr16). The channel
number should match the transmitting signal you chose when setting up the
transmitting product.
To sync multiple transmitters in one room, manually set each receiver and the
designated transmitter to a specific frequency and then perform the syncing
steps.
Freedom Par Quad-4 IP is fully compatible with the D-Fi 2.4 GHz wireless
transceiver (transmitter/receiver) from Chauvet (sold separately).
For more detailed information about D-Fi 2.4 GHz functionality, refer to the D-Fi 2.4
GHz User Manual available at the Chauvet website
Manual syncing is recommended for best results.
www.chauvetlighting.com.
Page 11 of 20
Advertisement
Table of Contents
