Proel Exaverb - Quick Start Guide - PROEL EXaverb User Manual

Proel Sound Processors User Manual
Proel exaverb – Quick Start Guide
To connect this unit you need unbalanced (TS) ¼" cables carrying line level signals from your
mixer, or other line level source, to be connected to ¼" jacks of this unit rear panel.
If your sound source is monophonic, please connect the cable to "LEFT/MONO" input jack only.
For stereo sound sources, use both "LEFT/MONO" and "RIGHT" jacks by connecting two discrete
cables to each of the two inputs.
Set the output level of your sound source (mixer or other line level source) and the input gain
("INPUT LEVEL") so that "CLIP" LED will never turn on.
Connect unit outputs ("OUTUPT LEFT" and "OUTPUT RIGHT") to your mixer effects return or
stereo line level input.
Please make sure "FX/BYPASS" LED is turned off.
Rotate the "OUTPUT LEVEL" knob until reaching the desired output signal level.
Now you can choose the effect you want to use by rotating the selection knob (7).
Using "MIX" knob set the quantity of direct signal (DRY) versus effect signal (WET) to be sent to
outputs.
In order to obtain the best possible results, please refer to page 14 connections examples.
4