Front Panel - PROEL EXaverb User Manual

Proel Sound Processors User Manual

Front Panel

1
2 3 4
5 6 7 8 9
11
10
1) INPUT LEVEL Knob
This knob allows you to set input signal gain.
2) Mix Knob
This knob is useful to balance original sound versus effect sound to zetaverb output. Rotating the
knob counter clockwise (towards "DRY") you'll listen more of the original signal. Rotating the knob
clockwise (towards "WET") you'll listen more effect.
3) OUTPUT LEVEL Knob
This knob sets the output level of overall signal from the processor.
4) CLIP LED
This LED turns on when the processor input signal level is too high. In this case you should reduce
the input level by "INPUT LEVEL" knob.
5) VARIATION Knob
This knob allows you to modify the value of the parameter associated to each effect.
Each effect parameters editable, using the "VARIATION" knob, are listed in TABLE 1 (page 11).
At each effect change the last selected parameter value is stored. When an effect is recalled the
stored parameter value is recalled regardless of current position of VARIATION knob. Thus, in this
condition by rotating the knob there could be no value exchange, unless the VARIATION knob
passes thru stored VARIATION value point. Once the VARIATION knob passes thru the stored
point, it's possible to modify the effect value. In order to verify that VARAITION knob has passed
the stored value point, you can see the FX/BYPASS LED (8), in this case the LED will briefly flash.
5