Rear Panel - PROEL EXaverb User Manual

Proel Sound Processors User Manual

Rear Panel

5
6
3 4
1 2
1) POWER - 9V AC power supply connector
Please connect here the supplied AC power transformer.
2) Product Label
3) TAP Footswitch Jack
¼" (6.3mm.) unbalanced (TS) jack for temporary, normally open footswitch (not supplied).
suggested footswitches PROEL model PFS20 or model PFS24 .
When "TAP DELAY" effect is selected, pressing at least two times the footswitch connected to
FX/BYPASS jack it's possible to set the desired delay time, according to music rhythm.
4) FX/BYPASS Footswitch Jack
¼" (6.3mm.) unbalanced (TS) jack for temporary, normally open footswitch (not supplied).
This jack allows to activate/deactivate the effect by pressing the footswitch.
When ROTARY effect is loaded, it doesn't allow you to turn on/off the effect, but you can stop the
horn and cylinder rotation by footswitch. In order to emulate real world status, horn and cylinder
stop position is totally random. Actually with different stop position you can hear different sound
pitches due to the stop position of the horn and cylinder.
5) LEFT & RIGHT OUTPUT Connections
Left and Right line output signals unbalanced (TS) ¼" (6.3mm.) jack connectors.
6) LEFT/MONO & RIGHT INPUT Connections
Unbalanced (TS) ¼" (6.3mm.) jack connectors for Left and Right line input signals from a mixer or
other line level analog sources.
In case of a mono source signal, it should be connected to LEFT/MONO input only.
1
7