Rear Panel - PROEL EXaverb User Manual

Proel Sound Processors User Manual
and "FIX/VAR" (7) buttons. Please notice that rotating this knob the system will not remove the
already activated notch filters.
7-11) FIX/VAR LED & Button
When this LED is lit, the system is in "VAR" mode, thus when feedback frequencies are no longer
detected after a certain amount of time, the system automatically resets all the activated filters.
When the LED is not lit, the system is in "FIX" mode, thus all the filters remain active until when
they are reset by rotating the "SENSITIVITY" knob to its "RESET-STOP" position.
When the system is in "FREEZE" mode, the activated notch filters cannot be reset, independently
by "FIX/VAR" button position.
8) Power On/Off button
Press this button to turn on/off the unit.
9) CLIP LED
This LED turns on when input signal level is too high. Adjust input signal level by "INPUT LEVEL"
knob so that this LED will not turn on.

Rear Panel

3
4
1 2
1) POWER - 9V AC power supply connector
Connect the supplied power supply to this connector.
2) Product label.
3) OUTPUT Connections
Unbalanced (TS) ¼" (6.3mm.) jack connectors for A and B line output signals. If the unit has been
set in "IN/OUT A" mode, please connect just one cable to A output.
4) Inputs Connections
A and B channels inputs on ¼" (6.3mm.) unbalanced (TS) jack connectors for line signal from a
mixer or other line level analog sources. If the unit has been set in "IN/OUT A" mode, please
connect just one cable to A input.
10