Measure Capacitance; Measure Frequency And Duty Cycle (107 Only); Maintenance - Fluke 106 User Manual

Measure Capacitance

1. Turn the rotary switch to
2. Connect the red test lead to the
3. Touch the probes to the capacitor leads.
4. After allowing the reading to stabilize (up to 18 seconds), read the capacitance value on the
display.

Measure Frequency and Duty Cycle (107 Only)

The Product can measure frequency or duty cycle while making either an ac voltage or an ac
current measurement. Push the
cycle.
1. When the Product is in the required function (ac voltage or ac current), push the
button.
2. Read the frequency of the ac signal on the display.
3. To make a duty cycle measurement, push the
4. Read the percent of duty cycle on the display.
106 & 107
Users Manual

Maintenance

Beyond replacing batteries and the fuse, do not attempt to repair or service your Meter unless
you are qualified to do so and have the relevant calibration, performance test, and service
instructions. The recommended calibration cycle is 12 months.
To prevent possible electrical shock, fire, or personal injury:
• Remove the input signals before you clean the Product.
• Use only specified replacement parts.
• Use only specified replacement fuses.
• Have an approved technician repair the Product.
For safe operation and maintenance of the Product, repair the Product before use
if the batteries leak.
18
.
terminal and the black test lead to the COM terminal.
button to change the Product to frequency or duty
button again.
Warning
Multimeters
Measurements
17