Test Diodes (107 Only); Measure Capacitance; Measure Frequency And Duty Cycle (107 Only) - Fluke 106 User Manual

106 & 107
Users Manual

Test Diodes (107 Only)

1. Turn the rotary switch to
2. Push the YELLOW function button twice to activate
Diode Test.
3. Connect the red test lead to the
black test lead to the COM terminal.
4. Connect the red probe to the anode side and the
black test lead to the cathode side of the diode being
tested.
5. Read the forward bias voltage value on the display.
6. If the polarity of the test leads is reversed with diode
polarity, the display reading shows . This can be
used to distinguish the anode and cathode sides of a
diode.
10

.

terminal and the

Measure Capacitance

1. Turn the rotary switch to
2. Connect the red test lead to the
black test lead to the COM terminal.
3. Touch the probes to the capacitor leads.
4. After allowing the reading to stabilize (up to 18
seconds), read the capacitance value on the display.

Measure Frequency and Duty Cycle (107 Only)

The Product can measure frequency or duty cycle while
making either an ac voltage or an ac current

measurement. Push the
to frequency or duty cycle.
1. When the Product is in the required function (ac
voltage or ac current), push the
2. Read the frequency of the ac signal on the display.
3. To make a duty cycle measurement, push the
button again.
4. Read the percent of duty cycle on the display.

.

terminal and the
button to change the Product

button.
