Table of Contents
Advertisement
4.4.7 Onboard Devices Configuration
The Onboard Devices Configuration menu allows you to change the onboard
devices settings. Select an item then press <Enter> to display the sub-
menu.
Advanced
Configure Win83627EHG-A Super IO Chipset
Serial Port1 Address
Serial Port2 Address
Serial Port2 Mode
Parallel Port Address
Parallel Port Mode
ECP Mode DMA Channel
Parallel Port IRQ
Serial Port1 Address [3F8/IRQ4]
Allows you to select the Serial Port1 base address.
Configuration options: [Disabled] [3F8/IRQ4] [3E8/IRQ4] [2E8/IRQ3]
Serial Port2 Address [2F8/IRQ3]
Allows you to select the Serial Port2 base address.
Configuration options: [Disabled] [2F8/IRQ3] [3E8/IRQ4] [2E8/IRQ3]
Serial Port2 Mode [Normal]
Allows you to select the Serial Port2 mode.
Configuration options: [Normal] [IrDA] [ASK IR]
Parallel Port Address [378]
Allows you to select the Parallel Port base addresses.
Configuration options: [Disabled] [378] [278] [3BC]
Parallel Port Mode [ECP]
Allows you to select the Parallel Port mode.
Configuration options: [Normal] [Bi‑directional] [ECP] [EPP]
EPP Version [1.9]
Allows selection of the Parallel Port EPP version. This item appears
when the Parallel Port Mode is set to [EPP] or [ECP & EPP].
Configuration options: [1.9] [1.7]
ECP Mode DMA Channel [DMA3]
Appears when the Parallel Port Mode is set to [ECP] or [ECP & EPP]. This
item allows you to set the Parallel Port ECP DMA.
Configuration options: [DMA0] [DMA1] [DMA3]
Parallel Port IRQ [IRQ7]
Sets the Parallel port IRQ. Configuration options: [IRQ5] [IRQ7]
4-26
BIOS SETUP UTILITY
[3F8/IRQ4]
[2F8/IRQ3]
[Normal]
[378]
[ECP]
[DMA3]
[IRQ7]
ENABLE: Allow
remapping of
overlapped PCI memory
above the total
physical memory.
DISABLE: Do not allow
remapping of memory.
Chapter 4: BIOS setup
Advertisement
Table of Contents
