Table of Contents
Advertisement
5.2.6 Rebuilding the RAID
This option is only for the RAID 1, RAID 5 and RAID 10 sets.
Rebuilding the RAID with other non-RAID disk
If any of the SATA hard disk drives included in the RAID array failed, the sys-
tem displays the status of the RAID volume as "Degraded" during POST. You
can rebuild the RAID array with other installed non-RAID disks.
To rebuild the RAID with other non-RAID disk:
1.
At the prompt, press <Ctrl> + <I> to enter the Intel Matrix Storage
Manager RAID configuration.
2.
If there is a non-RAID SATA Hard Disk available, the utility will prompt to
rebuild the RAID. Press <Enter>, then use up/down arrow keys to select
the destination disk or press <ESC> to exit.
"Degraded" volume and disk available for rebuilding detected.
Selecting a disk initiates a rebuild. Rebuild completes in the
operating system.
Select the port of destination disk for rebuilding (ESC to exit):
Select a destination disk with the same size as the original hard disk.
3.
The utilty immediately starts rebuilding after the disk is selected. The
status of the degraded RAID volume is changed to "Rebuild".
5-10
DEGRADED VOLUME DETECTED
Port Drive Model
3HDS722580VLSA80
[
]- Previous/Next
Serial#
VN6Bxxxx
[Enter]- Selects
[ESC]- Exit
Chapter 5: RAID Configuration
Size
76.7GB
Advertisement
Table of Contents
