Km 77 Torque Table #3 - Regulator - Kirby Morgan 77 Operation And Maintenance Manual

66 530-037
66 530-037
not numbered 530-037
not numbered 550-577
196 530-064
201 530-024*
202 530-022
203 530-220

KM 77 Torque Table #3 - Regulator

163 350-025
33 550-372
KM 77 Torque Table #4 - Communications
107 550-040
101 530-308
113 555-178
KM 77 Torque Table #5 - Miscellaneous
— 200-017
— 530-210
— 555-210
Note 1: Use Teflon tape for one to one and a half wraps, starting two threads back from the pipe thread end of the fit-
®
ting to avoid getting Teflon
Note 2: For a neoprene neck dam, re-torque every 12 to 24 hours.
* See Note 2 ** Use Loctite
Checklist, Maintenance, and Pre-Dive Inspections
For the most current check lists, helmet maintenance procedures, and pre-dive inspections, please check on
the Internet at www.divelab.com.
© ⅯⅯⅩIⅡ Kirby Morgan Dive Systems, Inc. All rights reserved. Document # 130318003
Screw, earphone retainer
Screw, snap tab
Screw, chin strap assembly
Nose block guide
Locking Collar Drawing
Screw, neck pad
Neck Ring Assembly Drawing
Screw, split ring
Screw, stepped ring
Screw, pull strap
Packing nut, regulator knob
Regulator mount nut
Mount nut, communications packing
Nut, communications posts
Packing nut, waterproof connector
Overpressure Relief Valve
Weld Lens Mount Bolt
Restrictor Adaptor
tape in the valve. Tighten pipe thread using good engineering practices.
®
222 or equivalent medium strength thread locking compound.
®
gland
Kirby Morgan
25
Loctite 248 Loctite
®
25
Loctite 248 Loctite
®
25
Loctite 248 Loctite
®
30
Loctite 268 Loctite
®
35
14
14
Loctite 222 Loctite
®
14
Loctite 222 Loctite
®
40
80
20
Snug—DO NOT overtighten
RTV Sealant
20
20
23
20
77
®
2.8
248
®
2.8
248
®
2.8
248
®
3.4
268
®
4
1.58
1.58
222
®
1.58
222
®
4.5
10
2.25
2.25
2.25
2.6
2.25
165