Securing The Premises; System Status - Honeywell LYNX Touch User Manual

Before arming your system, all protected doors, windows, and other protection zones must be
closed or bypassed (see the BYPASSING PROTECTION section).
READY LED: The green READY indicator on the control will be lit if the system is ready to
be armed. If blinking, the system is not ready.
ß Þ à á ë ❀ ❖ ✽ ◗ ❖ ❆ P ● ✽ ● ●
❍ ❅ ❆ ❆ ✽ ❈ ❏ ● ❏ P ❏ ✽ ❄
Depending on the current state of the system the following phrases may be heard:
fire alarm [zone voice descriptors]
carbon monoxide alarm [zone voice descriptors]
alarm [zone voice descriptors]
fire fault [zone voice descriptors]
carbon monoxide fault [zone voice descriptors]
fault [zone voice descriptors]
low battery [zone voice descriptor]
system low battery
check system
AC loss
zones bypassed
chime
VOLUME LEVEL: The volume level of system announcements can be increased or decreased. Refer to
the MESSAGE RECORDING/PLAYBACK section for the procedure.
The READY LED will be lit steadily once all protection zones have been closed or bypassed.
You may now arm the system.
❖ ❄ ❊ ❈ ■ ❈ ❘ ❆ P ❍ ❁ ✽ ❏ ● P ❆ ✽ ✾
◆ ❏ ❖ ✽ ● ❉ ● ❏ ✽ ❑ ✿

SECURING THE PREMISES

SECURING THE PREMISES SECURING THE PREMISES SECURING THE PREMISES
P ❆ ■ P ❘ ❋ ✽ ❲ P ❈ ▲ P ❆ ✽ P ❈ ❈ ❄ ❅
❁ ➼ ❪ ❁

System Status

❈ ❍ ✽ ▲ ❄ ❈ ❋ ❉ ■ ◆ P ◗ ◗ ❆ ❄ ◗ ❆ ■ P ❏ ✽ ■ ❈ ❏ ❖ ✽