❹
❷
❺
❻
❼
❷
❤
❽
❻
♠
❷
♦
❻
♠
❼
❸
Enter User Code (within eight seconds). Upon entering remote phone control mode the Lynx will
announce
System, enter code
❢
To remotely disarm system:........................................................... User Code + [1]
To remotely arm in AWAY mode: .................................................. User Code + [2]
To remotely arm in STAY mode: ................................................... User Code + [3]
To remotely arm in AWAY or STAY mode with no delay:.............. User Code + [2] or [3] + [0]
To remotely Bypass zones: ........................................................... User Code + [6] + zone no.
To remotely activate Forced Bypass: ............................................ User Code + [6] + [#]
To remotely check system status:.................................................. [
To end remote phone session: Hang Up or ................................. User Code + [9]
: (1) Check with your installer to see if the Forced Bypass mode has been enabled.
❿
➀
➁
➂
➃
(2) When bypassing zones, make sure a confirmation beep sounds for each zone that has been
bypassed.
❻
✐
♦
❻
❺
❺
❥
♠
❾
⑩
.
❣
Remote Phone Control Feature
]
✻
– 58 –
USER FUNCTIONS
USER FUNCTIONS
USER FUNCTIONS
USER FUNCTIONS