Kurt DL640 Installation & Operation Manual page 3

4. New Chip Guard system- The center clamping area is fully covered
100% of the time. Note: The stationary chip guard may need to be
removed when the vise is used with the optional conversion kit. See
conversion kit assemble section.
5. New Locating hole patterns- The clamp down mounting holes that
will fit a standard 2" grid pattern found in sub-plates available through
several industrial suppliers. The base includes four precision 5/8" holes
in the bottom for accurate re-location. Also available are two 16mm
holes that will fit a 100mm and/or 200mm grid patterns found in metric
sub-plates. (See locating and mounting hole sketch for reference). The
use of Sine Keys would also provide mounting the Vise to machine
tables with key slots if needed.
6. New Stationary Jaw- The DoubleLock vise has a precision locator for
accurate repeatability. This gives the Stationary Jaws exact relocation
when used with interchangeable Stationary Jaw setups or re-setup from a
convertible model.
7. Convertible models- When the DL640 or DL430 is needed for a single
large part clamping, the maximum opening is 10.69" to a minimum of
2.69", and 8.20" to 2.1" on the DL430. This is a continuous travel
opening.
Kurt offers quick change one-sided Aluminum carvable Moveable Jaws for
conversion into a carvable vise. Optional internal hex is also available. (Contact
factory for information and costs).
These important features and functions make Kurt's new DoubleLock an
accurate, durable, affordable "user friendly" vise. Combined with the industries
only ten (10) year warranty. The Kurt DoubleLock vises fills all your CNC
WorkHolding needs.
2