Kurt DL640 Installation & Operation Manual page 11

2. Before placing the (2) Movable Jaws over the Nuts make sure the
segments are in the inside cavity using grease to hold them in place and
for lubrication.
3. Spread a small amount of oil to the bed of the vise where the Moveable
Jaws will be installed.
4. Place the Movable Jaw starting with the side with (2) holes into the
center way. In a slide motion, slide Movable Jaw over the Nut allowing
the Movable to drop over the Nut. NOTE: The 45-degree angle of the
Nut should be on the flat surface of the Movable Segment.
5. Snap the Chip Guard onto the pins underneath each Moveable. Note:
May need to lift up slightly to catch the pins with the Chip Guard.
6. Tighten the SHSS in the Movable until it makes contact with the Nut.
Turn back approximately ¼ turn. IMPORTANT: THIS SHSS SHOULD
NOT BE COMPLETELY TIGHT. THIS WILL ALLOW MOVEMENT
OF THE MOVABLE JAWS. SEE SKETCH ON NEXT PAGE.
7. Place the Stationary Chip Guard into place.
8. Install the Stationary Jaw and tighten in place using the (2) SHCS.
9. To seat the segments in the Movable Jaw, tighten vise with supplied
handle, and then open vise until close to full opening. If needed tighten
the SHSS in the back of Movable Jaws then loosen approximately ¼ turn.
10. Vise is now ready for use.
10