Control Input/Telephone Paging-To-Group Assignment Operation - Toa VM-2120 Instruction Manual

[Operation for zone selection and its cancellation]
• Pressing a currently flashing or quickly flashing zone key for any zone not selected will select that zone (the
zone indicator then remains steadily lit or slowly flashes).
• Conversely, if a currently selected zone key is pressed, that zone will then be deselected. ("Selected" and
"deselected" states are alternately changed with each press of the key.)
[Dual indication of group and zone selections]
The indicators for set zones remain steadily on, while those for unset zones flash. However, if a zone with the
same number as the group number is selected, the corresponding indicator slowly flashes*. (This provides a
dual indication of Group and Zone selection.) When the same number zone is not selected, the indicator
quickly flashes*. (This provides a dual indication of Group selection and Zone deselection.)
* See p. 45 Indicator status.

24.4. Control Input/Telephone Paging-to-Group Assignment Operation

Here, the operation example of assigning Input 1 to Broadcast Groups 1, 2, and 3 will be explained.
(See p. 41 "Input 1 to group" setting example.)
Step 1. Entry to setting mode
Press and release the Reset key while holding down the
ZONE 1 and ZONE 4 keys. When all indicators for
Zones 1 – 5 begins to flash (2 – 3 seconds after),
release both the ZONE 1 and ZONE 4 keys.
The unit will be placed in setting mode.
The 5 indicators for ZONE 1 through ZONE 5 begin to
flash.
Step 2. Setting item selection (Example: Input 1)
Press the ZONE 1 key to select the Input 1.
Note that the ZONE 1 key functions as the selector key
for "Input 1."
The ZONE 1 indicator will slowly flash* to indicate that
Input 1 was selected.
Pressing other selector key will change the setting item
assigned to each zone key as shown on the right.
(Though the Zone 5 indicator flashes, no setting item is
assigned to the Zone 5 key.)
Step 3. Setting item programming
Press the POWER switch.
The Input 1 will be programmed and the unit will be
placed in Group Selection mode for Input 1.
The ZONE 1 indicator changes from "quick flashing" to
"slow flashing", while the remaining indicators for zones
2 – 5 and "ALL" (All zones) stay steadily on. This
represents that Input 1 has been selected, and "ALL
zones" (not "ALL groups") has been set. (Default
setting)
46
ZONE 1 ZONE 4
Input 1
ZONE 1 ZONE 2 ZONE 3 ZONE 4
Input 1 Input 3 TEL paging
Input 2
ZONE 1 ZONE 2 ZONE 3 ZONE 4
Zone 1
(Input 1)
ZONE 1 ZONE 2 ZONE 3 ZONE 4
Reset
ZONE 5 ALL
ZONE 5 ALL
Zone 5
ZONE 5 ALL