44
After the console has been seated, separate the individual
cables out of the end of the console cable assembly and
attach them to the appropriate circuit connectors inside the
console. Refer to the following diagram and table to identify
the cables and connectors.
Important: All cables must pass through the opening in the center
of the console mount.
Figure 29: Cable connections, P30 and P10 consoles
Table 3. P30 and P10 internal cable connections
Cable
Safety key
(treadmills only)
Data from base
unit
Heart rate sensors Four-contact strip, keyed
CSAFE
Assembling and Maintaining TRM 800-Series Treadmills
Connector Type
Six-contact strip, keyed
Eight-contact modular, on
flat gray cable
Eight-contact modular, on
flat gray cable
Circuit Connector
Location