Section 18: Throttle Pushrod And Fuel Tank - Hangar 9 P-51 Mustang 1.50 ARF Assembly Manual

Section 18: Throttle Pushrod and Fuel Tank

Required Parts
• Fuel tank assembly
• Throttle pushrod tube (15")
• Throttle pushrod (17
• Fuel tubing (red and green)
Required Tools and Adhesives
• Drill Bit: 1/8"
• Felt-tipped pen
• Masking tape
Step 1
Determine the proper location for the throttle pushrod.
Mark the location with a felt-tipped pen and drill the
firewall for the pushrod tube using a drill and 1/8" drill
bit. Remove the engine if necessary.
• Foam: 1/4", 1/2"
1
/ ")
4
• Drill
• Hobby knife
Step 2
Test fit the throttle pushrod tube through the firewalland
into the fuselage. Once satisfied with the fit, mix1/4 ounce
of 6-minute epoxy and glue the pushrodinto the firewall.
Allow the epoxy to fully cure before continuing.
Step 3
Trim the throttle pushrod tube so it extends 1" onto the
servo tray.
49